JSW Steel’s Q3 Production Analyzed
JSW Steel made 7.48 million tonnes of raw steel in the third quarter of the financial year 2026. This is 6% more than they made in the same period last year. A key reason for this change is a temporary shutdown of one of their factories.
Key Points
- JSW Steel produced 7.48M tonnes of raw steel in Q3 FY26.
- Production increased by 6% compared to the previous year.
- Blast Furnace 3 is offline for a capacity upgrade.
- Factory capacity use dropped due to BF3’s downtime.
- Indian operations at 93% capacity, BF3 reduced to 85%.
- JSW Steel USA production remained consistent with prior quarter.
One of JSW Steel’s factories, called Blast Furnace 3, was closed for a few months to make it bigger and better. This happened from the end of September 2025 and is scheduled to reopen by the end of the fourth quarter of 2026. Because of this, the company didn’t use its factories as much as it could in India during that time.
Here’s a breakdown of how much steel they made: Approximately 7.28 million tonnes of steel came from their Indian operations. Without the closed factory, they would have made about 7.66 million tonnes. However, with the factory closed, the total amount was reduced by 5%.
JSW Steel USA, which has a factory in Ohio, produced 0.2 million tonnes of steel, a similar amount to the previous quarter. Overall, JSW Steel produced 7.48 million tonnes of steel for the entire company.
When you add in the small amount of steel made during a test run (0.12 million tonnes), the total production goes up to 7.59 million tonnes. This represents a 6% increase compared to the same time last year.
It’s important to note that the factory’s capacity was reduced to 85% when it was closed. This shows how important each factory is to the company’s overall production.
Ultimately, JSW Steel’s production performance highlights the strategic importance of operational upgrades and capacity utilization.
